Tap the lock to lock and unlock selected settings. ② Mic Selection/Settings Lock Tap the caret to access settings for your microphone.
#LIGHT COMPRESSOR SETTINGS PODCAST SOFTWARE#
If you’re having trouble visualizing that, here’s a better representation of what I mean.① Settings Click the three dots to access MOTIV software information, manage presets, application preferences and check for firmware updates. If you have very strong peaks, you’re going to want more aggressive ratios to normalize your levels. The lower the ratio you select will affect your audio less. The greater the ratio you select, the more aggressively the compressor will reduce the peak levels. The ratio you select will be applied to only signals above the threshold discussed earlier. Instead, the compressor applies a reduction ratio to the signals in order to maintain some dynamics. RatioĬompressing your audio does not mean it’s a hard limit. Usually the system defaults will be fine. A fast attack time might seem jarring if you were expecting a louder signal, and so on. A slow attack time will run the risk of clipping, but it gives instruments like the snare drum more punch. Play around with this, but be aware that you may want to cut up your speech track a bit if you want to use different measures. This can get a bit sticky, but ultimately we’re talking about milliseconds here. This setting tells the DAW how fast to apply and how long it should take to stop the compressor effect. There’s no right or wrong answer here, but you’re going to have to listen to your voice over and over to see what makes sense for you. You may want to play around with this a bit, but in general I use -6dB so I have more freedom to laugh on mic. Only sounds above that level will be compressed. The threshold is the point where you want the compressor to start bringing your peaks under control. To avoid this, use the compressor (or sometimes called “speech volume leveler”) to bring the peaks of your voice below the clipping point, and the quietest parts up to an audible level. As always, record with the highest bit depth you can. This is accomplished by reducing the dynamic range of a track in a way that’s not going to damage the quality (much). A compressor can be used to prevent clipping in samples, as well as bring up the levels of quieter sounds in your voice recording. Consequently, you’re going to want to use what’s called a “compressor” to help even these out.
#LIGHT COMPRESSOR SETTINGS PODCAST HOW TO#
Unlike your brain, your recording equipment will likely not know how to interpret wild swings in volume. The DAW will then remove the noise based on the patterns you’ve given it, removing crackles and hisses from your file even when there’s other sound present. Don’t miss: Audio mixing 101: Everything you need to know to create your first track You should aim to have at least 5-10 seconds of noise to give the DAW, but that’s probably a little overkill. The cleaner the sample of noise is, the better it’s removed from the final recording. Many DAWs will have a de-noise option where you can select sections of nothing but noise to train the program to remove the right stuff. See where there are noise peaks on the voice recording, and then turn down the level until there’s no more (or very little) noise.
0 kommentar(er)
